Interior

Video #1 Discusses the Mercy-2/4 Interior Kit.
Video #2 Discusses how to transform your Fiero seat into a Supercar-Replica seat.
Video #3 Discusses the Fiero Headrests.
Video #4 Discusses the MERCY-1 Interior with Diamond Tuck Stitching.
(Full screen is located at the bottom right of each YouTube video)
#1

For the round dash vents you can go to lambostuff.com
and buy part number 009414507 for $31.48 or go to
eBay and search for a 1999-2005 Pontiac Grand Am,
Round 3" Dash VENT and pay about $5.00 for a used vent.
You will need 4 dash vents to go in your MERCY dash.
(see photo of a Pontiac dash vent below.)

This video explains how to prepare the fiberglass FIERO
head-rest before it is installed onto the top part of a
FIERO or FIREBIRD's metal seat frame.
You will have to cut the metal seat frame so that the
finished seat will not be too high sitting in the car.

THE FIERO HEADREST IS INSTALLED ON THE FIERO SEAT IN THE PHOTO ABOVE AND NOTICE THE BLACK MARKING THAT READS ( CUT LINE 5") YOU WILL NEED TO CUT THE FIERO METAL SEAT FRAME 5" FROM THE LINE THAT IS IN THE FOAM SO THAT THE SEAT WILL FIT THE CAR. ALSO NOTICE THE BOTTOM PART OF THE SEAT HAS THE DIAMOND SQUARES STITCHED INTO THE BLACK VINYL. NOTE: THE DATE WAS SET WRONG ON THE CAMERA THIS PHOTO WAS TAKEN 01/04/2010.

THE BLACK MARKINGS SHOW WHERE TO CUT THE FIBERGLASS ON THE FIERO HEAD-REST PHOTOED ABOVE.



	MERCY-4 REPLICA SEATS BASE IN FIREBIRD SEAT.

Interior

Made in USA